Vista 50P Programming Manual

23 Oct 2023

Device timers the system provides up to 20 timers which can be used to control various devices, such as lights or appliances. Web new zone programming and 5800 wireless device enrollment procedure important!

Ademco Vista 50p Ademco

Vista 50P Programming Manual. User manual (72 pages) , installation and setup manual (112 pages) 1. To enter programming mode (using an alpha keypad connected to the control) : To enter programming mode (using an alpha keypad connected to the control) :

Set The Keypads (And Other Peripheral Devices) To The Appropriate Addresses.

Set factory defaults by pressing 97. Device timers the system provides up to 20 timers which can be used to control various devices, such as lights or appliances. Web new zone programming and 5800 wireless device enrollment procedure important!

Power Up, Then Press [ ] And [#] At The Same Time, Within 50 Seconds Of Powering Up (This Method Must Be Used If 98 Was Used To Exit Program.

14 expert mode zone programming. The sections at the core of the manual include both hardware setup and programming requirements of each device to make that specific device operational in the system. The wiring and physical setup of the hardware follows.

13 5800 Series Transmitters Loop Designations.

10 programming with #93 menu mode. A checkout procedure is included at the end of each section. Refer to the using schedules section at the end of this manual for scheduling related procedures.

A Downloaded From Www.manualslib.com Manuals Search Engine.

Vii conventions used in this manual. • #93 menu mode main menu options • zone programming • serial number programming • alpha programming • device programming • relay programming • relay voice descriptors • custom index programming (vip module substitute words). User manual (72 pages) , installation and setup manual (112 pages) 1.

Power Down Then Back Up And Press * And # Within 1 Minute Move To Location * + Location

Step 1 2 3 4 5 action enter output programming in the #93 menu mode. Ademco vista series commercial bulgary partitioned security system with scheduling. Set the keypads (and other peripheral devices) to the appropriate addresses.

Partitioned Security System With Scheduling.

This section provides the following information: Web beginning of the manual, followed by the basics of programming. Two programming forms are provided:

4140 + 8 + 0 + 0 (Display Should Show 00) Or 2.

48 this manual is also suitable for: Web closing time, using temporary schedules, or by programming special user schedules. To enter programming mode (using an alpha keypad connected to the control) :